|
Relatively New and Unpainted/To Be Painted/With Elastomeric
- Surface Preparation:
- if efflorescence is present, remove by hand wire brushing; wear eye protection and gloves; try to identify and eliminate any source of water from behind the stucco that could have caused the efflorescence
- scrape out and widen any cracks; brush out dust, and seal with 100% acrylic or siliconized acrylic caulk; make second application in several hours if needed; wall and chimney caps must be sound and continuous; chimney flue should have rain cover
- treat any mildew with a 3:1 water:household bleach mixture, leaving it on for 20 minutes and adding more as it dries; wear eye and skin protection; rinse thoroughly
- remove dirt, chalk, dust, unbound sand, treated mildew, etc. by scrubbing with detergent and water, and rinse thoroughly; or power wash with plain water, taking care to not drive water into cracks or porous areas
- Priming:
- priming is necessary to ensure maximum durability and resistance to efflorescence, alkalinity and mildew
- use quality exterior latex primer that is recommended for masonry or stucco
- do not leave a primer unpainted
- Painting:
- use top quality exterior 100% acrylic elastomeric wall coating
- apply two coats for maximum crack bridging and durability
- apply at manufacturer’s recommended spread rate; for best performance, this will be 40 - 60 sq.ft./gallon to achieve a minimum dry film thickness of 7 mils per coat.
Back to Exterior Prep, Prime and Paint
|
